Property Drone
Register FAQ Calendar Mark Forums Read

Go Back   :: E30owners.com :: Your BMW E30 website > E30 - General > Members E30's

Members E30's Show the rest of us your E30

Reply
 
Thread Tools Display Modes
  #1  
Old 29-10-2016, 06:32 PM
liamobzr's Avatar
liamobzr liamobzr is offline
Premium Member (Site Supporter)
 
Join Date: Aug 2009
Location: Co. Kildare
Posts: 258
Default Temp guage not working after m20b20 to m20b28 swap

Checked the zone wiki and it said the following;

" To test, first unplug the C101 and earth pin 4 (brown/purple wire). Now if you switch the ignition on, the gauge should go to full hot. If it does, repeat the test at the brown plug by removing the cable from the brown plug, and earthing the terminal with a piece of wire (for older cars with two-pin terminals, just bridge them together). If it now works, the issue is normally corrosion of the C191 plug."

only problem is there is no pin 4 on my c101 its empty

any suggestions greatly appreciated!
__________________


“Faster, Faster, until the thrill of speed overcomes the fear of death.”
Hunter S. Thompson
Reply With Quote
Advertisement
Reply



Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT +1. The time now is 03:01 PM.
Privacy Policy


Copyright ©2000 - 2017, Jelsoft Enterprises Ltd. E30owners.com is in no way affiliated with BMW AG or any of the BMW Group of Companies. Contact Us - e30owners.com - Archive - Top